When you happen to notice that some of the tiles in your property are coming loose and are in need of repair already, it would be best for you to have it fixed the moment you notice its discrepancies that prolonging the damage as this may cause you to go overboard with your budget. In addition to that, it is also not good for you to just left the tiles that are coming loose as it will not only come off and break, its shards may cause you or anyone who will come over to trip and cause them to suffer injuries. Know that there are so many ways on how you can deal with tiles that are coming loose and some of which are a whole lot better than the others.
As what we have mentioned above, there are lots of ways on how you can handle tiles that are coming loose like pulling them all up and replacing them all. But then again, the downside of replacing all the tiles that are coming loose is that it is not only expensive, there goes the fact that it can be messy and time consuming as well. Since the concern that you have is the few tiles that are coming loose, there is no need for you with replacement as you can just opt for a tile repair instead.
And since you feel like choosing tile repair over tile replacement, we want you to be informed about the things that you have to do before you proceed with it like cleaning the tiles first using a household cleaner. If you have already cleaned the tiles and make it as spotless as you can, what you should do next is to put the special ceramic glue onto the areas where the cracks are present. You should use the knife to force the damaged tile to stick to the floor and also, you can use it to smooth the damaged area as well. Once you have placed the damaged tile again to the floor, you must not move it from one place to another since you have to let the glue work for twenty four hours.
Once the glue dried down, in order for you to soften the texture and the feel of the tiles, you should use sandpaper to sand it. You have to continue sanding down the dried glue until you achieve an area that is completely flat. You should not be rough when sanding the dried glue, instead, you have to be quick and be light at the same time.